Mitel SX-200 Documentation page 31

To define which Recording Group an Automatic Wake-Up will be rout-
ed to, the console dials:
Dial ~234
l
Dial Recording Group access code
Press RELEASE to terminate.
l
To delete an existing Automatic Wake-Up recording, the console
should dial a # in place of the Recording Group access code.
Incoming Trunks
5.10 SMDR must be enabled to run on incoming trunks. Also, all UCD
trunks must be programmed as DIL to the Agent Groups in-
tended to serve them. It must be noted that for proper operation of a
UCD facility, the trunks must be able to initiate a release. Otherwise,
abandoned calls will remain queued (and eventually be answered by
Agents), thereby placing an unnecessary load on the system.
Call Data
5.11
Account code usage by the Agents can easily record valuable
data (in the standard SMDR record) retrieved from the calls
handled.
6. ~UPERSET Sets
Introduction
6.01 The
telephone set (Figure 6-l). The set uses a liquid crystal display
(LCD) for line status indication and user prompting. In addition the
lection. For specific information on the SUPERSET 4 set features; see
Section MITL9105/91 lo-096-107-NA. The SUPERSET 3 is also a micro-
processor-controlled electronic telephone set (Figure 6-2) and pro-
vides a subset of the SUPERSET 4 features without the LCD display
(see Section MlTL9105/91 lo-096-106-NA). Either SUPERSET set can be
used only with a SUPERSET Line Card. Standard telephones are not
compatible with this Line Card.
7. SUPERSET 3 Set
General
7.01
The SUPERSET 3 set provides the following operational fea-
tures:
Single button feature activation.
l
Multiline appearances (installer-programmed) of up- to three
lines including primary line -(set directory number). Multiline
appearances may be a mixture of lines and trunks, and may also
be multi-appearances of same line.
SECTION MITL9105/9110-096-l OO-NA
4 is a microprocessor-controlled electronic
Page 25