Mitel SX-200 Documentation page 757

SE&ON MITL9105/911 O-096-500-NA
TABLE 6-4
MAINTENANCE FUNCTION ACCESS CODES
To select any of the functions, the access code assigned for the maintenance function must be
dialed (Feature Number 19). The code 555 is used in the following part for the maintenance code
This may be dialed from the test line or console.
Clear all errors:
(b) Go off-hook
(a) Dial 555 + 1.
(c) Dial 555 + 8 + # (or 2).
Direct trunk or station access:
(a) Dial 555 + 20
(b) Dial individual equipment number
(3-digit equipment number for trunk
or station).
To busy out a receiver:
(a) Dial 555 + 3
(b) Dial equipment number of receiver.
To busy out of a speech path:
(a) 'Dial 555 + 33
(b) Dial speech path number (01-31).
To initiate system dump (from console):
(a) Dial 555 + 71x - dial tone returned
(b) Dial xl4#
(c) Press RELEASE button.
To suspend printer (Note 3):
(a) Dial 555 + 8 + x (or l), or
(b) Dial x14x console only.
To enable printer (Note 3), .
(a) Dial 555 + 8 + x (or 2), test line
(b) Dial *14# console only
(c) Press RELEASE button.
To debusy a receiver:
(a) Dial 555 + 4
(b) Dial equipment number of receiver.
To debusy a speech path:
(a) Dial 555 + 43
(b) Dial speech path number (01-31).
To initialize card slot:
(a) Dial 555 + 5
(b) Dial card slot number (01-17, 31-42).
System reset (Notes 2 and 3):
(a) Dial 555 + 6.
To initiate system dump (from test line):
(a) Dial 555 + 71x and hang up
To purge and ignore printer (Note 3):
(a) Dial 555 + 8 + 00, test line
(b) Dial xl400 console only
(c) Press RELEASE button.
To print stored Customer Data:
(a) Dial 555 + g + n, where n is:
0 A complete print (Note 4)
1 System Options, Feature Access
Codes, Classes of Service, Hunt
Groups and Extensions
2 Trunk and Trunk Group Data
3 Special Set Data
4 Toll Control Data
5 Speed Call Data
6 Automatic Route Selection Data
x Systemwide Data (Note 5)
(b) Press RELEASE button.
Notes: 1. For Traffic Measurement Access Codes, see MITL9105/gl lo-Og6-450-NA.
2. The thumbwheel switches on the Tone. Control card should be set to XXYX, where X =
any digit 0 - 9 and Y cannot be the digit 7.
3. Requires System Options Programming.
4. This prints all sections.
5. This will print only the systemwide speed call tables and the system special set <-'
messages.
6. To dump data blocks, see Part 5, Subpart H of this Section.