Mitel SX-200 Documentation page 55

Superswitch electronic private automatic branch exchange epabx

Hide thumbs Also See for SX-200:

Table of Contents

Introduction

This Section contains a description of the features and services

provided by the SX-100 and SX-200 (PBX) systems. The selec-

tion of features and services are subject to minimal constraints, allow-

ing each system to be configured to meet the individual requirements

of the customer.

Reason for issue

This Section has been issued to provide Generic 217 informa-

tion for the SX-100 and SX-200 systems.

Detailed instructions for the programming and testing of each

feature and service are given in the following sections:

For information on the SUPERSET 3 set, see Section MITL9105/

For information on the SUPERSET 4 set, see Section MITL9105/

9 110-096-l 07-NA, Features and Services Description.

2. FEATURES AND SERVICES DESCRIPTION

Introduction

This Part contains a description of each feature and service

provided by the SX-100 or SX-200 system. Each description

contains four parts:

Description - a detailed description of the feature or service.

Conditions - a list of any special conditions which should be

taken into account when selecting the feature or service.

Programming - the parameters which must be programmed to

allow selection and operation of the feature or service.

Operation - a brief description of the feature operation. In a

number of attendant feature operations, the * symbol is shown.

This is the attendant function access code (Feature Number 18)

and can be programmed as any symbol or number that may be

dialed from the console dial pad. Description of maintenance

feature operation assumes the access code 555 (Feature Num-

ber 19) is used. The SX-lOO/SX-200 Console Operating Instruc-

SECTION MITL9105/9110-096-105-NA

Chapters

Table of Contents