Mitel SX-200 Documentation page 24

SECTION MlTL91 OS/91 10-096-l 00-NA
FIELD display, which rooms correspond to a particular status .
condition.
MSGE WAIT. This feature is enabled by the attendant calling a
room and pressing the MSGE WAIT button. This causes the
room telephone to receive a burst of three rings every 20
minutes.
DO NOT DISTB. This feature enables a guest at his request not
to receive incoming calls.
CALLBACK. This button allows the attendant to access the
automatic callback feature.
CANCEL. The CANCEL button is used to cancel a misdialed or
busy call.
HOLD l-4. The attendant can place a current call on hold by
pressing one of the HOLD buttons. The associated LED will light
to indicate that the hold circuit is busy.
CALL BLOCK. Rooms and all vacant rooms may be restricted
from calling other rooms for specific time periods.
FLASH. This button is pressed to flash the telephone company
operator on long-distance calls. The FLASH button may be
programmed as the SERIAL CALL button or a silent MONITOR i
button.
SERIAL CALL. This button is pressed to enable incoming Cen-
tral Office calls to recall to the console when the called station
hangs up.
GUEST ROOM. When this button is pressed and the room
number dialed, Guest Room information will be displayed.
1 . The room number and the "Message Register" status in the
SOURCE display.
The "Room Status" indicated by a digit (followed by "." if the
2 .
maid is in the room) and a set Wake-Up in the Destination
display.
The "Do Not Disturb:' status (indicated by DO NOT DISTB lamp).
The "Message Waiting" status (indicated by MSGE WAIT lamp).
4.
The "Controlled
5.
ROOM RESTR lamp).
6 . Automatic Wake-Up
CONF. The conference button is used to set up an attendant
conference. The associated LED flashes to indicate a recall from
Outgoing Restriction" status (indicated by
c