Mitel SX-200 Documentation page 646

SECTION MITL9105/911 O-096-450-NA
TABLE 2-1
TRAFFIC REGISTER LISTING AND DESCRIPTION
Reg.
No.
Description
A - SYSTEM SERVICES AND CONSOLE ACTIVITY
001 3 Second Dial Tone Delay Peg Count.
This register is incremented every time that
an extension or dial-in trunk has to wait 3 or more seconds for dial tone. it does
not include the Test Line.
002 Extension Originations Peg Count.
Each time an idle extension goes off-hook it
causes this register to increment by one count. It does not increment when a
ringing extension goes off-hook
003
Receiver Peg Count.
This register is incremented every time an extension or trunk
is given a receiver.
004 2 Second Dial Tone Delay Peg Count.
This register is incremented every time that
an extension or dial-in trunk has to wait 2 or more seconds for dial tone. It does
not include the Test Line.
005 Maximum Junctors.
At each scanning interval, the number of junctors in use is
determined and compared to the number held by the active register. If the number
is greater than that held by the register, it replaces the held number. The register
will thus reflect the maximum of junctors which were used at any one time during
the traffic hour. The value will include the two junctors used by the diagnostics.
Even if the system handled no calls, the register will contain a "2" (unless the
system was in the programming mode).
006
Junctor Usage.
At each scanning interval the number of junctors in use are added
to the value contained in the register. At the end of the traffic hour the register will
thus reflect the total usage of the junctors during the period. It includes the use of
junctors by the diagnostic and thus will not be zero even if the system handled no
calls during the period.
007 1 Second Dial Tone
Delay Peg Count. This register is incremented every time an
extension or dial-in trunk has to wait 1 or more seconds for dial tone. It does not
include the Test Line.
008 Vacant/Illegal Calls Peg Count.
This register increments whenever an extension,
the attendant or a dial-in trunk dials a vacant or illegal number. It increments
regardless of whether intercept to attendant or Reorder Tone occurs.
009
System Activity Peg Count.
Each time a line or trunk card interrupt is processed,
or a timer expires, this register increments. It thus provides a relative measure of
system activity to determine the busiest hour during a Traffic Measurement run.
010
Calls Waiting Usage.
At each scan the number of calls waiting in the attendant
queue is added to the register. The hourly accumulation represents the occupancy
of calls waiting (in ccs).
011
Calls to Attendant Peg Count.
This register contains a count of all calls directed
to the attendant. It includes calls that hang up before they are answered. The
register total will not be the sum of the following register totals because aban-
doned calls are not included.
012 LDN 1 Peg Count.
This register is incremented for each Incoming LDN (Local Direc-
tory Number) 1 call answered by the attendant.
Page 3