Mitel SX-200 Documentation page 348

1. GENERAL
Introduction
This Section contains a description of the features and services
1 .Ol
provided by the SUPERSET 3.
Reason for Issue
1.02 This Section is issued to include the features and services of
the SUPERSET 3 when used with SX-lOO@ and SX-200@ Private
Automatic Branch Exchange (PABX) Systems.
General
This Section contains a description of the features and services
1.03
provided by the SUPERSET 3.
The features and services available are determined by the PABX
1.04
the SUPERSET 3 is used with.
The SUPERSET 3 can be used only with the Subscriber Line
1.05
interface Card (SLIC).
Detailed instructions for the programming of each feature and
1.06
service are given in the following MITEL Practices:
sx- 1 oo/sx-200
l
l
2. DEFINITIONS
2.01 Prime Key -
sion number is the SUPERSET's identity.
2.02
Personal
separates the prime line into outgoing and incoming parts.
Allows an outgoing call without making the prime line busy to incom-
ing calls. It shares programming information with the prime line.
2.03 Key Line
or may not be a SUPERSET prime line. It may appear on one
can be programmed independently. If busy on one set, it is busy on all
sets. Privacy release is needed to allow a second set to connect to this
line.
2.04 Multiple Call
set with an appearance may answer. Only sets programmed to
ring will ring. Immediately after answer, it is available for an incoming
call to all remaining appearances. You can have as many simultaneous
incoming calls as you have appearances. An incoming c&II lights all
SECTION MITL9105/9110-096-106-NA
Information
It is the primary line on the SUPERSET. The exten-
Outgoing Line
Features and Services Description
Page 1