Mitel SX-200 Documentation page 108

SECTION MITL9105/9110-096-105-NA
AUTOMATIC WAKE-UP (ALARM CALL)
Page 54
Description
This feature allows either the Attendant or an extension user to set up
a Wake-Up alarm call that will ring the extension at a prearranged
time. After answering a Wake-Up alarm call, the extension user re-
ceives either a special tone (100 ms ON, 400 ms OFF, of miscellaneous
tone), music or a Recorded Announcement. If the call is not answered
within six rings, or if the extension is busy, the call will repeat two
more times at 5 minute intervals.
Conditions
A Wake-Up call will be delayed if there are 10 Wake-Up calls in
the ringing state or if there are only four free speech paths. The
remaining Wake-Up call(s) will be initiated as soon as conditions
allow.
An extension with "Do Not Disturb" will be overridden and rung
at the requested time.
System Option 300 (Traffic Measurement Polling) and System
Option 248 (Automatic Wake-Up Print) are mutually exclusive.
If a power failure occurs when the system is reset, then all
wake-ups within the previous 2 hour period (by the new time
setting) will be honored within 5 minutes.
If a power failure occurs for a period in excess of 24 hours, all
wake-ups should be cancelled, because the system will
ber the time but the date is not stored. The wake-up call when
answered may be connected to an external recording device for
a specific recorded announcement (see Recorded Announce-
ment).
Select System Option 245 (Automatic Wake-Up Enable) if the
Wake-Up call is to beset from the console. To have a minor
alarm raised at the console if a Wake-Up is not answered after
three attempts, select System Option 246 (Automatic Wake-Up
Alarm to Attendant Enable).
For a printed copy of all Wake-Up requests and attempts, select
System Option 248 (Automatic Wake-Up Print).
A Wake-Up/Alarm call may be answered using Dial or Directed
Call Pickup. Once answered, the Wake-Up/Alarm* call is can-
celled.
For music when the Wake-Up call is answered, select System
Option 247 (Automatic Wake-Up MOH).
For an extension to set Automatic Wake-Up, select Class-
of-Service Option Number 82 (Alarm Call Enable).
For an extension to set Automatic Wake-Up, assign an access
code to Feature Number 30 (Alarm Call).
All RADs/RACs must be added to a Recording Group.
A RAD must be connected to a regular line (extension) circuit
and defined by the Attendant.
The maximum number of Wake-Up calls routed to the recording
group will be equal to the number of recording devices in the
group. If the recording group is busy then the called extension
will hear a special tone or MOH.