4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove bolts -arrows- and detach poly V-belt tensioner -1-.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Fit poly V-belt
⇒ page 39
Specified torques
♦
⇒ "1.1.2 Exploded view - poly V-belt drive, vehicles with air
conditioner compressor", page 37
1.4
Removing and installing vibration damp‐
er
Special tools and workshop equipment required
♦ Counter-hold tool - T10475-
Removing
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation; Removing and installing noise
insulation .
– Remove poly V-belt
– Loosen bolt -arrow- of the vibration damper, using the coun‐
terhold tool - T10475- to do so.
– Remove bolt and take off vibration damper.
Note
Risk of damage to engine.
♦
To avoid disturbing valve timing, do not turn the crankshaft
♦
when the vibration damper has been removed.
Installation
Note
Renew bolts that are tightened with specified further tightening
♦
angle.
All contact surfaces between bolt, vibration damper and crank‐
♦
shaft toothed belt pulley must be free of oil and grease.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 38
.
León 2013 ➤ , León ST 2013 ➤
1. Cylinder block (pulley end)
41