Seat Leon 2013 Workshop Manual page 62

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Fasten assembly tool - T10134- together with the sealing
flange -1- to the crankshaft flange -2-.
– For this purpose, screw the hexagon socket head bolt -E- with
a hexagon key approx. 5 rotations into the crankshaft flange.
– Push guide pin for petrol engines (red handle) -F- into crank‐
shaft flange.
– Screw in 2 M6x35 bolts -2- to guide the sealing flange -1- into
the cylinder block.
Securing assembly tool - T10134- on crankshaft flange:
– Press the assembly housing -C- by hand in the direction of the
-arrow- until the sealing lip support ring -1- lies on the surface
of the crankshaft flange -2-.
– Check that the guide pin for petrol engines (red handle) -F- is
seated correctly in the hole in the crankshaft. This ensures that
sender wheel reaches its final installation position.
Note
The guide pin for diesel engines (black handle) must not be in‐
serted in threaded hole of crankshaft.
– Tighten the two hexagon socket head bolts on assembly tool
hand-tight.
– Screw nut -B- onto threaded spindle by hand until it lies against
assembly housing -C-.
Pressing sender wheel onto the crankshaft flange using assembly
tool - T10134- :
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Tighten nut -B- on assembly tool - T10134- to 35 Nm.
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
• A small gap must be present between cylinder block and seal‐
ing flange after tightening nut to 35 Nm -1-.
56
Rep. gr.13 - Crankshaft group