Separating Engine And Gearbox - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove bolts -arrows- and detach engine mounting -1-.
Note
Danger of damage to vacuum lines or electrical wiring and to
♦
engine compartment.
Check that all vacuum lines and electrical wiring between en‐
♦
gine, gearbox, subframe and body have been detached.
Carefully guide out engine/gearbox assembly with subframe
♦
from engine compartment when raising.
Make sure that air conditioner compressor and refrigerant
♦
pipes and hoses are not damaged.
Do not stretch, kink or bend refrigerant pipes and hoses.
♦
Carefully lift the »engine/gearbox unit« upwards when remov‐
♦
ing it, in order not to damage the bodywork and the coolant
hoses.
Secure engine to engine and gearbox support - VAS 6095- to
♦
carry out repairs ⇒ page 19
1.2

Separating engine and gearbox

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Special tools and workshop equipment required
♦ Hook - 10 - 222 A /2-
♦ Shackle - 10 - 222 A /12-
18
Rep. gr.10 - Removing and installing engine
.