Seat Leon 2013 Workshop Manual page 107

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Install toothed belt cover (bottom section) -arrows-.
– Install vibration damper
⇒ "1.4 Removing and installing vibration damper", page 41
Perform remaining installation steps in reverse sequence of re‐
moval.
Specified torques
♦ ⇒ "1.1 Exploded view - poly V-belt drive", page 35
♦ ⇒ "2.1 Exploded view - toothed belt cover", page 82
♦ ⇒ "2.2 Exploded view - toothed belt", page 83
♦ ⇒ Fig. ""Plug for TDC drilling in cylinder block - tightening tor‐
que"" , page 84
♦ ⇒ "1.2 Exploded view - camshaft housing", page 70
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
♦ ⇒ "3.1 Exploded view - crankcase breather system",
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
page 140
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ ⇒ "2.1 Exploded view - coolant pump and thermostat",
page 157
♦ ⇒ "1.1 Exploded view - turbocharger", page 189
♦ ⇒ "2.1 Assembly overview - charge air system", page 197
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Assembly overview - noise insulation
León 2013 ➤ , León ST 2013 ➤
.
2. Toothed belt drive
101