Seat Leon 2013 Workshop Manual page 179

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unplug the electrical connector -2-.
Note
Place a cloth underneath to catch escaping coolant.
– Pull off retaining clip -1- and pull radiator outlet coolant tem‐
perature sender - G83- out of connection -3-.
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Replace the O-ring.
♦
Insert new coolant temperature sender - G62- immediately in‐
♦
to connection in order to avoid loss of coolant.
– Install front noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
– Check the coolant level ⇒ page 155 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Coolant pump/thermostat assembly
173