Seat Leon 2013 Workshop Manual page 264

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Work sequence
– Cut through the exhaust pipe at a right angle at the position
marked -arrow- using chain pipe cutter - VAS 6254- .
– Position clamp centrally at side marks -arrows- when instal‐
ling.
– Fit rear clamp ⇒ page 257
– Align exhaust system without tension
1.2.2 Disconnecting exhaust pipes/silencers,
Leon ST
♦ The connecting pipe can be cut through at the cutting point in
order to renew the centre and rear silencers separately.
♦ Cutting location is marked by an indentation on circumference
of exhaust pipe.
Special tools and workshop equipment required
♦ Chain-type pipe cutter - VAS 6254-
258
Rep. gr.26 - Exhaust system
.
⇒ page 261
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.