Seat Leon 2013 Workshop Manual page 51

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unscrew the bolts -1, 2, 3-.
Note
Make sure that all lines of the exhaust temperature sender are
not exposed to tension and that they are not damaged when re‐
moving the »engine support«.
– Adjust the engine/gearbox assembly as needed using the
spindle of the support bracket - 10-222 A- .
– Pull out engine support downwards.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Fit the engine support and hand-tighten -1, 2 and 3- firmly.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Fit the lower toothed belt guard and tighten to a torque of 8
Nm.
– Tighten screws -1, 2 and 3- on the engine support - to a torque
of ⇒ page 26
Note
Renew bolts that are tightened with specified further tightening
♦
angle.
All contact surfaces between bolt, vibration damper and crank‐
♦
shaft toothed belt pulley must be free of oil and grease.
León 2013 ➤ , León ST 2013 ➤
1. Cylinder block (pulley end)
45