Seat Leon 2013 Workshop Manual page 106

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Tighten bolt -1- of camshaft adjuster on inlet side -2- initially
to 50 Nm.
– Use counter-hold tool - T10554/1- and counter-hold tool -
T10172- to do this.
• After the toothed belt has been fitted and the bolts have been
secured, the engine should be cranked clockwise by one com‐
plete turn.
• Crank engine until the camshafts and crankshaft have re‐
turned to TDC position.
Rotate crankshaft to "TDC" as follows:
– Set piston in cylinder no. 1 to TDC position.
⇒ "2.3 Checking distribution timing", page 84
– Tighten bolt -1- to final specified torque
⇒ "2.2 Exploded view - toothed belt", page 83
hold tool - T10172- with adapter -T10172/2- and -T10172/1- .
– Use counter-hold tool - T10554/1- and counter-hold tool -
T10172- to lock camshaft in position (push in »clockwise
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
direction«).
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Tighten bolt -1- for camshaft adjuster to final specified torque
⇒ "2.2 Exploded view - toothed belt", page 83
– Tighten plug -1- to specified torque.
⇒ "2.2 Exploded view - toothed belt", page 83
– Use counter-hold tool - T10172- with counter-hold tool -
T10554/1- to do this.
100
Rep. gr.15 - Cylinder head, valve gear
using counter-
.