León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Switch on tester -VAS 6394/1- by pressing button -A- once
briefly.
Note
When button -A- is pressed for 2 seconds, the illumination is
♦
switched on for 20 seconds.
If tester -VAS 6394/1- does not indicate 0 bar, zero the tester
♦
⇒ Operating instructions .
– Connect vehicle diagnostic tester .
– Start engine and run at idling speed.
– Select "Engine electronics" in the self-diagnosis program.
– Then select the "measured values".
– Select "Fuel pressure" from the list.
– Compare pressure displayed on tester -VAS 6394/1- with ac‐
tual value displayed on vehicle diagnosis tester .
– Observe fuel pressure displayed on vehicle diagnostic tester.
•
A maximum pressure deviation of 5 bar is permissible
– If deviation is greater than 5 bar, renew fuel pressure sender
- G247- .
– Repeat the check with the new fuel pressure sender - G247-
and compare both measurement values.
– If measured values are now the same, install new fuel pres‐
sure sender - G247- .
– If measured values are not the same again, check electrical
connection between fuel pressure sender - G247- and engine
control unit - J623- ⇒ Current flow diagrams, Electrical fault
finding and Fitting locations.
238
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.