Seat Leon 2013 Workshop Manual page 133

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
1 - Dipstick
❑ Oil capacities
⇒ page 130
❑ Min. and max. mark
⇒ page 129
2 - Sealing cap
3 - Breather valve
❑ Note installation posi‐
tion
4 - O-ring
❑ renew
❑ Moisten with oil before
installing.
5 - Guard plate
❑ For oil separator
6 - Oil pressure switch for re‐
duced oil pressure F378
❑ Screw in by hand by ap‐
prox. 3 full turns.
❑ 20 Nm
❑ Checking ⇒ page 144
❑ Removing and installing
⇒ page 143
7 - Oil sump
❑ Removing and installing
⇒ page 130
8 - Oil filter
❑ 20 Nm
❑ See note ⇒ page 126
❑ If outer circumference of
oil filter is damaged, re‐
new oil filter.
❑ Removing and installing ⇒ Maintenance ; Booklet 501 .
❑ If the connecting union for oil filter in sump became loose
9 - Oil seal
❑ renew
10 - Oil level/oil temperature sender - G266-
❑ Removing and installing
11 - Bolt
❑ 8 Nm
12 - Bolt
❑ Tightening torques and tightening sequence
13 - Oil seal
❑ renew
Note
New procedure for all subsequent
maintenance work:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
⇒ page 137
⇒ page 129
León 2013 ➤ , León ST 2013 ➤
⇒ page 130
⇒ page 128
127
1. Sump, oil pump