Seat Leon 2013 Workshop Manual page 60

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Securing sealing flange with sender wheel onto assembly tool -
T10134- :
– Screw on nut -B- until just before it touches the clamping sur‐
face -A- of the threaded spindle.
– Clamp assembly tool - T10134- in a vice -1- on tightening flats
-A- of threaded spindle.
– Press assembly housing -C- downward so that it rests against
nut -B-.
• Inner part of assembly device and installation socket must be
level with each other.
– If fitted, remove securing clip -arrow- from new sealing flange
-1-.
Note
Do not take the sensor wheel out of the sealing flange or rotate it
out of position.
– Secure the sealing flange by the front on a flat, clean surface.
– Press sealing lip support ring -1- downwards in direction of
-arrow- until it touches flat surface.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
54
Rep. gr.13 - Crankshaft group
respect to the correctness of information in this document. Copyright by SEAT S.A.