Seat Leon 2013 Workshop Manual page 15

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Separate the air hose -2- from the air filter housing.
– Carefully remove the air filter housing -1- from the retaining
bolts in an upward motion, sequentially.
– Loosen the brackets -arrow- for the air duct hose.
– Disconnect the air filter housing -1- with the air duct hoses.
– Remove bolts -arrows-.
Note
Item -2- can be disregarded.
– Unlatch the air duct in the lock carrier and remove
-in the direction of the arrow-.
– Remove battery and battery tray ⇒ Electrical system; Rep. gr.
27 ; Battery; Removing and installing battery tray .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Unplug electrical connector -1- for radiator fan (push retainer
respect to the correctness of information in this document. Copyright by SEAT S.A.
to the rear -arrow A- and press down release catch).
– Press locking tabs on left and right sides of radiator cowl
-arrow B- and at the same time lift radiator cowl off radiator.
– Remove noise insulations ⇒ Rep. gr. 66 ; Noise insulation;
Exploded view –noise insulation .
Note
After removing of coolant or fuel lines, these must be sealed using
the engine sealing cap set - VAS 6122- to prevent dirt from en‐
tering or coolant or fuel from running out.
León 2013 ➤ , León ST 2013 ➤
1. Removing and positioning the engine
9