Seat Leon 2013 Workshop Manual page 18

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Place drip tray under unit for workshop cranes - VAS 6208-
and then unfasten each retaining clip in turn -Arrows-, then
dismantle the coolant hoses from the heat exchanger on the
heating unit.
– Move clear vacuum hose at air intake pipe -2-.
– Unscrew bolt -2- and remove screw-type clip.
– Remove bolt -1- and nuts -arrows- and tie up catalytic con‐
verter.
Note
Do not bend decoupling element more than 10°. It may be dam‐
aged
– Unscrew bolts -arrows- and remove bracket.
– Loosen hose -2- for activated carbon filter.
– Disconnect connector -1-.
– Open the catch mechanisms with a screwdriver -Arrow-.
– Loosen the hose clip -3-, remove the coolant hose.
12
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.