Seat Leon 2013 Workshop Manual page 61

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
• The upper edge of the sealing lip support ring -1- must be flush
with the front edge of the sealing flange -2- -arrows-.
– Place front side of sealing flange -1- on assembly tool -
T10134- so that locating pin -D- is seated in hole -3- in sender
wheel -2-.
• Ensure that sealing flange lies flat on assembly tool.
– Screw knurled screws -H- onto sealing flange -1-.
– When tightening, press sealing flange -1- and sealing lip sup‐
port ring -2- against surface of assembly tool - T10134- .
– This prevents the locating pin from slipping out of the sensor
wheel hole.
– When installing sealing flange, ensure that sensor wheel re‐
mains fixed in assembly device.
Securing assembly tool - T10134- with sealing flange -1- on
crankshaft flange:
• Crankshaft flange must be free of oil and grease.
• Engine is at "TDC" position.
– Screw nut -B- to end of threaded spindle.
– Press threaded spindle of assembly tool - T10134- in direction
of -arrow- until nut -B- makes contact with assembly housing
-C-.
– Point the flat part of the installation socket towards the sealing
surface of the engine block in contact with the oil sump.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Cylinder block, gearbox end
55