León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove line guide -1- from its clips, slide upwards
-in direction of arrow- and secure on one side.
Manual gearbox
– Remove shift actuation ⇒ Rep. gr. 34 ; Shift actuation; Re‐
moving and installing shift actuation .
– Removing the clutch slave cylinder ⇒ Rep. gr. 30 ; Clutch
actuation; Clutch slave cylinder: removing and installing .
Dual clutch gearbox
– Remove selector lever cable, pull connector of mechatronic
off and remove all retainers from gearbox ⇒ Rep. gr. 34 ;
Removing and installing gearbox .
Continued procedure for all vehicles
– Disconnect connector -1- of the oil level and oil temperature
sender - G266- .
– Unscrew bolts -1, 2 and 3-, and remove pendulum support.
– Remove bolts -arrows- and detach heat shield for drive shaft
(right-side).
16
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.