Seat Leon 2013 Workshop Manual page 266

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Loosen clamp -arrow- at front, and push it forwards.
– Remove front silencer.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Align exhaust system without tension
Specified torques
♦ ⇒ "1.1 Exploded view - silencers", page 253
♦ ⇒ "2.1 Assembly overview - emission control", page 263
♦ ⇒ General body repairs, exterior; Rep. gr. 50 ; Underbody
trim; Assembly overview - underbody trim panels
1.3.2 Removing and installing rear silencer
Removing
CAUTION
Risk of accident caused by high weight of silencers.
– Seek help from a second a mechanic for the following work.
Leon SC, 5 door model
Separating point without clamp
– Separating silencer
⇒ "1.2 Disconnecting exhaust pipes/silencers", page 257
Separating point with clamp
– Loosen clamp -arrow-, and push it forwards.
– Remove bolt -2- on both sides.
– Remove rear silencer -1-.
Leon ST
Separating point without clamp
– Separating silencer
⇒ "1.2 Disconnecting exhaust pipes/silencers", page 257
Separating point with clamp
– Loosen clamp -arrows-, and push it forwards.
260
Rep. gr.26 - Exhaust system
⇒ page 261
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
.