Removing And Installing Poly V-Belts - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
1.2

Removing and installing poly V-belts

⇒ "1.2.1 Poly-V belt: Removing and installing, vehicles without air
conditioner compressor", page 38
⇒ "1.2.2 Poly-V belt: Removing and installing, vehicles with air
conditioner compressor", page 39
1.2.1 Poly-V belt: Removing and installing,
vehicles without air conditioner com‐
pressor
Special tools and workshop equipment required
♦ Locking pin - T10060 A-
Removing
– To slacken poly V-belt, turn tensioner in anti-clockwise direc‐
tion -arrow-.
– Lock tensioner with locking pin - T10060 A- .
Note
If a used poly V-belt runs in the opposite direction when it is
♦
refitted, this can cause breakage.
♦ Before removing the Poly-V belt, mark the direction of rotation
with chalk or felt-tipped pen for re-installation.
– Remove the V-ribbed belt.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Install the poly V-belt as depicted in the illustration:
1 - Vibration damper
2 - Tensioner for poly V-belt
3 - Alternator
38
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.