Removing And Installing The Air Intake Pipe - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Install air ducts with screw-type clips
Note
Hose unions and air intake pipes/hoses must be free of oil and
♦
grease when installing.
Secure all hose connections with the hose clips corresponding
♦
to original equipment ⇒ Electronic parts catalogue .
Specified torques
1 - Hose clip -a- = 13 mm wide: 5.5 Nm
2 - Hose clip -b- = 9 mm wide: 3 Nm
2.2 Removing and installing the air intake
pipe
Special tools and workshop equipment required
♦ Release tool - T10527-
♦ Release tool - T10527/1-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Removing
– Move clear vacuum hose at air intake pipe -2-.
Note
The catch -arrow- for the vacuum hose -1- does not need to be
released for this procedure.
– Move clear air hoses at charge air pipe.
– Open hose clips -arrows-, and remove air hose -1-.
– Pull connector off charge pressure sender - GX26- .
Note
Make sure to use the new tools to prevent the locking lugs of the
air intake pipe from breaking off.
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Supercharger air system:
199