Seat Leon 2013 Workshop Manual page 279

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unplug the electrical connector -1-.
– Unscrew bolt -2- and remove engine speed sender - G28- .
Installation
Note
Carefully insert engine speed sender - G28- in bore!
♦
This will prevent the engine speed sender - G28- from falling
♦
between engine and gearbox.
– Installation is in the reverse sequence of removal.
– Install front noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
Specified torques
♦ ⇒ "1.1 Assembly overview - ignition system", page 268
♦ ⇒ "2.2 Exploded view - electric coolant pump", page 159
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
1. Ignition system
273