León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Note
The ignition coils are easier to remove when the engine is
♦
warm.
The grease which is used for the initial installation of the spark
♦
plug enables the plugs to be released easily when the engine
is hot.
Ignition coils with output stage and spark plug connectors are
♦
available individually for repairs ⇒ ETKA (Electronic Parts
Catalogue)
Removing
Ignition coils for "cylinders 2, 3, 4":
– Remove resonator for intake air
⇒ "3.3 Removing and installing resonator for intake air", page
227
.
All ignition coils (continued):
– Unscrew bolt -1-.
– Push puller - T10530- into hole in ignition coil -1- to stop.
– Tighten knurled nob -2- in -direction of arrow-.
270
Rep. gr.28 - Ignition system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.