Seat Leon 2013 Workshop Manual page 175

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Spanner - T10508-
♦ Release tool - T10527- and release tool - T10527/1-
Removing
– Drain coolant ⇒ page 150
– Free air hose from air pipe.
– Open hose clips -arrows-, and remove air hose -1-.
– Pull connector off charge pressure sender - GX26- .
Note
Make sure to use the new tools to prevent the locking lugs of the
air intake pipe from breaking off.
– Remove air intake pipe
⇒ "2.2 Removing and installing the air intake pipe",
page 199 .
– Release hose clip -4- and detach coolant hose -3-.
– Remove bolts -arrows- and detach cover -2- from thermostat
housing -1-.
– Remove thermostat using special wrench - T10508- .
– Slightly push down special wrench - T10508- and turn it in
-direction of arrow- while doing so.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Coolant pump/thermostat assembly
169