Seat Leon 2013 Workshop Manual page 183

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– First push the coolant pipe onto the mounting -1- until it en‐
gages.
– Then push the coolant pipe onto the mounting -2- until it en‐
gages.
– Check that the coolant pipe has properly engaged by pulling
on it.
Installation is carried out in the reverse order. Please note the
following:
Note
Renew gaskets and O-rings.
♦
Secure all hose connections with the hose clips corresponding
♦
to original equipment ⇒ Electronic parts catalogue .
– Install intake manifold
⇒ "4.2 Removing and installing intake manifold", page 229
Specified torques
♦ ⇒ "3.1 Exploded view - coolant pipes", page 174
♦ ⇒ "4.1 Intake manifold - exploded view", page 228
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
.
177
3. Coolant pipes