León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Removing
– Switch off ignition.
– Unplug the electrical connector -1-.
– Pull off securing clip -2- using locking tool - T40265- .
– Remove bolts -arrows- and detach charge pressure positioner
- V465- .
Installation
Installation is carried out in the reverse order. Please note the
following:
•
Renew securing bolts for charge pressure positioner
-arrows-.
•
Renew circlip -2-.
– Adapt engine control unit - J623- to charge air pressure con‐
troller - V465- using ⇒ Vehicle diagnostic tester; "guided func‐
tions" .
Specified torques
♦
⇒ "1.1 Exploded view - turbocharger", page 189
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
196
Rep. gr.21 - Turbocharging/supercharging
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.