Seat Leon 2013 Workshop Manual page 157

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Draining off
– Open filler cap -arrow- on coolant expansion tank.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
– Set drip tray for workshop hoist - VAS 6208- underneath.
– Disconnect connector -2- from radiator outlet coolant temper‐
ature sender - G83- -3-.
– Pull out retaining clip -1-, remove lower left coolant hose from
radiator and drain off coolant.
– Release retaining clip -arrow-, remove lower right coolant
hose from radiator for charge air cooling circuit and drain off
remaining coolant.
charge
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
1. Cooling system/coolant
151