Seat Leon 2013 Workshop Manual page 243

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Work sequence
CAUTION
The fuel system is under high pressure.
Risk of injury due to fuel which may spurt out.
– Release high pressure.
– ⇒ "1.2 Reducing fuel pressure in high-pressure section", page
208
Note
Risk of functional impairment due to soiling.
– Observe the.
⇒ "2.1 Safety precautions when working on fuel supply sys‐
tem", page 2
– Remove fuel pressure sender - G247-
– Lubricate taper seal of adapter -VAS 6394/3- with clean en‐
gine oil and screw into fuel rail (22 Nm).
– Unscrew plug -2- and screw fuel pressure sender - G247- into
tester -VAS 6394/1- .
– Connect pressure line -1- of tester to adapter - VAS 6394/3- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Establish the electrical connection between vehicle and fuel
pressure sender - G247- using the test instrument adapter/
DSO (3-pin) - VAS 5570- .
⇒ page 235 .
León 2013 ➤ , León ST 2013 ➤
237
5. Sensors