Removing And Installing Camshaft Oil Seal - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
3.5 Removing and installing camshaft oil
seal
⇒ "3.5.1 Removing and installing camshaft oil seal for inlet cam‐
shaft, belt pulley end", page 111
⇒ "3.5.2 Removing and installing exhaust camshaft oil seal, pulley
end", page 113
⇒ "3.5.3 Sealing ring on exhaust camshaft (transmission side):
removing and installing", page 114
3.5.1 Removing and installing camshaft oil
seal for inlet camshaft, belt pulley end
Special tools and workshop equipment required
♦ Assembly tool - T10478 B-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Puller hooks - T20143-
Removing
Note
The illustrations may show the exhaust side.
♦
However, the procedure must be performed in the same way
♦
on the inlet side.
– Remove camshaft adjuster on inlet side
⇒ "3.3 Removing and installing camshaft adjuster",
page 104 .
León 2013 ➤ , León ST 2013 ➤
3. Valve control
111