Seat Leon 2013 Workshop Manual page 58

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Assembly tool - T10134-
♦ Bolt M6x35 (3x)
Work sequence
• Gearbox removed
• Tightening torque
⇒ Fig. ""Plug for TDC drilling in cylinder block - tightening tor‐
que"" , page 84
Note
For illustration purposes, the procedure is shown with the engine
removed.
– Remove the flywheel
– Remove intermediate plate -1- from dowel sleeves
-arrows A-.
– Guide intermediate plate -1- upwards.
– While doing so, pull retaining lug -arrow B- of intermediate
plate -1- out of recess behind sealing flange.
– Turn crankshaft to "TDC".
⇒ "2.3 Checking distribution timing", page 84
– Remove oil pans
⇒ "1.3 Removing and installing sump", page 130
– Remove the engine speed sender - G28- -arrow-
⇒ "1.6 Removing and installing engine speed sensor G28 ",
page 272 .
– Unscrew bolts -arrows- for sealing flange -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
52
Rep. gr.13 - Crankshaft group
⇒ page 50 .
respect to the correctness of information in this document. Copyright by SEAT S.A.
.