Cooling System Thermostat: Removing And Installing - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Pull off the electrical connector -1- from the charge air cooler
pump - V188- .
– Set drip tray for workshop hoist - VAS 6208- underneath.
– Disconnect coolant hoses at the pump for charge air cooler -
3094- with hose clips -V188- .
– Loosen the hose clips -3-, remove the coolant hoses.
– Unscrew bolt -2- and remove charge air cooling pump - V188- .
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Secure all hose connections with the hose clips corresponding to
original equipment ⇒ Electronic parts catalogue .
– Install front noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
– Check the coolant level
Specified torques
♦ ⇒ "2.2 Exploded view - electric coolant pump", page 159
2.7 Cooling system thermostat: removing
and installing
⇒ "2.7.1 Removing and installing thermostat for large cooling cir‐
cuit", page 168
⇒ "2.7.2 Removing and installing thermostat for small cooling cir‐
cuit", page 170
2.7.1 Removing and installing thermostat for
large cooling circuit
Special tools and workshop equipment required
♦ Hose clip pliers - VAS 6362-
168
Rep. gr.19 - Cooling
⇒ page 155 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.