Seat Leon 2013 Workshop Manual page 255

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Note
Use cloth to catch escaping fuel.
– Unscrew union nuts -arrows- and detach high-pressure pipe.
Installation
Installation is carried out in the reverse order. Please note the
following:
– Lubricate threads of union nuts with clean engine oil.
– Initially, tighten union nuts for high-pressure pipe by hand on
high-pressure pump (make sure that pipe is not under ten‐
sion).
Note
Use an open-end wrench to counterhold at the hexagon on the
high-pressure pump when tightening to the final specified torque.
– Tighten union nuts using torque wrench - VAS 6854- and insert
- T10395/3- .
– Install throttle valve module - GX3-
Specified torques
♦ ⇒ "7.1 Exploded view - high-pressure pump", page 245
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 232 .
León 2013 ➤ , León ST 2013 ➤
7. High-pressure pump
249