Seat Leon 2013 Workshop Manual page 19

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove clip -2-, remove coolant hose and remove the coolant
expansion tank.
Note
Item -1- can be disregarded.
CAUTION
The fuel system is pressurised.
Risk of injury due to fuel which may spurt out.
– Use safety goggles.
– Wear protection gloves.
– Release pressure: place clean cloth around connection and
carefully open connection.
– Observe rules for cleanliness when working on the fuel supply
system
⇒ "2.1 Safety precautions when working on fuel supply sys‐
tem", page 2 .
– First press hose connector -1- downwards, and then press re‐
lease tabs -arrows-.
– Pull off hose connector, keeping release tabs depressed.
– Press release tab on hose -2- connected to activated charcoal
filter.
– Disconnect hose and move it clear.
Note
Use removal lever - 80 - 200- to lever out the wiring clips when
performing the next work steps.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Remove engine control unit - J623- ⇒ page 239 .
León 2013 ➤ , León ST 2013 ➤
1. Removing and positioning the engine
13