Seat Leon 2013 Workshop Manual page 49

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Loosen hose -2- for activated carbon filter.
– Disconnect connector -1-.
– Release detent using a screwdriver -arrow- and place coolant
expansion tank to one side.
– Remove tensioner for poly V-belt
⇒ "1.3 Removing and installing tensioner for poly V-belt", page
40
– Loosen bolt -1- but do not remove.
– Unscrew bolt -2-.
– Swivel alternator -3- in -direction of arrow- towards front.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Screw out bolts -arrows- from the retainer of the front exhaust
pipe.
– Disconnect connector -1- of the oil level and oil temperature
sender - G266- .
León 2013 ➤ , León ST 2013 ➤
1. Cylinder block (pulley end)
43