Seat Leon 2013 Workshop Manual page 159

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Connect coolant hose to water radiator for charge air cooling
circuit (bottom right) -arrow-.
– Fill reservoir of -VAS 6096- with at least 10 litres of premixed
coolant (according to recommended ratio):
– Screw down adapter for cooling system tester - V.A.G 1274/8-
to coolant expansion tank.
– Connect cooling system charge unit - VAS 6096- to adapter -
V.A.G 1274/8- .
– Run vent hose -1- into a small container -2-.
Note
Exhaust air takes a slight quantity of coolant along with it; this
should be collected.
– Close both valves -A- and -B- (turn lever at right angles to di‐
rection of flow).
– Connect hose -3- to compressed air.
• 6 ... 10 bar of working pressure.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
1. Cooling system/coolant
153