Seat Leon 2013 Workshop Manual page 91

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Camshaft clamp - T10494-
♦ Assembly tool - T10487-
♦ Release tool - T10527- and release tool - T10527/1-
♦ Screwdriver with minimum shaft length of 250 mm (not illus‐
trated)
Work sequence
– Remove resonator for intake air
⇒ "3.3 Removing and installing resonator for intake air", page
227 .
– Free air hose from air pipe.
– Open hose clips -arrows-, and remove air hose -1-.
– Pull connector off charge pressure sender - GX26- .
Note
Make sure to use the new tools to prevent the locking lugs of the
air intake pipe from breaking off.
– Remove air intake pipe
⇒ "2.2 Removing and installing the air intake pipe",
page 199 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Toothed belt drive
85