Seat Leon 2013 Workshop Manual page 28

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– If there are no dowel sleeves -A- in cylinder block for centring
engine and gearbox, insert new ones.
– Bolt gearbox to engine at positions -1, 2, 3, 6, 7, 8, and 9-.
The engine/gearbox unit is inserted into the engine compartment
with the assembled engine and gearbox supports.
– Using the lifting tackle - 2024 A- and the workshop crane -
VAS 6100- insert the engine/gearbox unit.
Note
Make sure that air conditioner compressor and refrigerant
♦
pipes and hoses are not damaged.
Do not stretch, kink or bend refrigerant pipes and hoses.
♦
– Support the gearbox mounting on the longitudinal member in‐
itially.
Note
Carefully lower the »engine/gearbox unit« downwards when in‐
stalling it, in order not to damage the bodywork and the coolant
hoses.
Note
Attach drive shafts to corresponding flange shafts of gearbox.
22
Rep. gr.10 - Removing and installing engine
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.