Seat Leon 2013 Workshop Manual page 204

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
❑ Removing and installing
12 - Charge air pressure sender - GX26-
❑ comprising:
Charge-air regulator - G31-
Intake air temperature sensor - G42-
❑ Removing and installing
13 - O-ring
❑ renew
14 - Air conduction tube
❑ Removing and installing
15 - Connection
16 - O-ring
❑ renew
❑ Before installing, lightly moisten O-ring with clean engine oil
17 - O-ring
❑ renew
❑ Before installing, lightly moisten O-ring with clean engine oil
18 - Bolt
❑ Thread-forming
❑ Fit and screw in bolt by hand so that it is screwed into old thread. Then tighten the screw with the stated
torque
❑ 7 Nm
19 - Retaining clip
❑ for air pipe
20 - Throttle valve control mechanism - GX3-
❑ comprising:
Throttle valve control mechanism - J338-
Throttle valve drive (electric power control) - G186-
Throttle valve drive angle sender 1 (electric power control) - G187-
Throttle valve drive angle sender 2 (electric power control) - G188-
❑ Removing and installing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
21 - Oil seal
respect to the correctness of information in this document. Copyright by SEAT S.A.
❑ renew
22 - Seal
❑ 4 pieces
❑ renew
198
Rep. gr.21 - Turbocharging/supercharging
⇒ page 235
⇒ page 200
⇒ "2.2 Removing and installing the air intake pipe", page 199
⇒ page 232