Engine: Fitting - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Secure engine with pins -arrows- on engine and gearbox sup‐
port - VAS 6095- as shown in illustration.
1.4

Engine: fitting

Work sequence
• Attach power unit with the aid of the lifting device - 2024 A-
and the workshop crane - VAS 6100- .
Note
Renew bolts that are tightened with specified further tightening
♦
angle.
Renew self-locking nuts and bolts, and seals, O-rings and
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
gaskets.
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Secure all hose connections with the hose clips corresponding
♦
to original equipment ⇒ Electronic parts catalogue .
Attach cable ties in all the same places when installing.
♦
– Install intermediate plate ⇒ page 50 .
León 2013 ➤ , León ST 2013 ➤
1. Removing and positioning the engine
21