Exploded View - Camshaft Housing - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Cylinder head - tightening torque and sequence
Note
Renew bolts that are tightened with specified further tightening
angle.
– Tighten bolts in stages in the sequence shown:
stage Bolts
1. -1 ... 10-
2. -1 ... 10-
3. -1 ... 10-
4th -1 ... 10-
Check that the cylinder head is not deformed
– Use straight edge 500 mm - VAS 6075- and feeler gauge to
measure cylinder head for distortion at several points.
• Maximum permitted deformation: 0.05 mm
1.2

Exploded view - camshaft housing

70
Rep. gr.15 - Cylinder head, valve gear
Tightening torque/angle specification
40 Nm
turn 90° further
turn 90° further
turn 90° further
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.