Seat Leon 2013 Workshop Manual page 176

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Installation
– Insert thermostat ensuring that the centring pin of thermostat
is seated in guide -arrow-.
– Install thermostat using special wrench - T10508- .
– Slightly push down special wrench - T10508- and turn it to stop
in -direction of arrow- while doing so.
Installation is carried out in the reverse order. Please note the
following:
Note
Renew gasket.
– Moisten gasket with coolant.
– Fill up with coolant ⇒ page 150
Specified torques
♦ ⇒ Fig. ""Cover for thermostat to thermostat housing - tighten‐
ing torque"" , page 159
2.7.2 Removing and installing thermostat for
small cooling circuit
Removing
– Remove coolant pump
– Remove bolts in the sequence -F ... A-.
– Detach coolant pump from thermostat housing.
170
Rep. gr.19 - Cooling
.
⇒ page 162 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.