Seat Leon 2013 Workshop Manual page 29

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
• Screw in bolts -arrows- by hand until stop in the gearbox sup‐
port -1-.
• Screw in bolts -arrows- by hand until stop in the engine bracket
-1-.
Note
Different types of brackets are fitted depending on version.
Note
The bolts are tightened to final torque only after adjusting the as‐
sembly mountings ⇒ page 32
– Install starter ⇒ Electrical system; Rep. gr. 27 ; Starter; Re‐
moving and installing starter
– Install air intake pipe
– Install air ducts ⇒ page 199
Vehicles with manual gearboxes
– Install clutch slave cylinder ⇒ Rep. gr. 30 ; Clutch mechanism;
Removing and installing clutch slave cylinder .
– Install Bowden cables with counterholders ⇒ Rep. gr. 34 ;
Shift actuation; Selector lever cable, removal and installation .
Vehicles with dual clutch gearbox:
– Install selector lever cable, fit connector of mechatronic and
install all retainers on gearbox: ⇒ Rep. gr. 34 ; Removing and
installing gearbox
Continued procedure for all vehicles
– Install radiator cowl
– Install catalytic converter
– Install drive shafts ⇒ Running gear, axles, steering; Rep. gr.
40 ; Drive shaft; Removing and installing drive shafts .
– Install the air conditioner compressor: ⇒ Heating, Air condi‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
tioning; Rep. gr. 87 ; Air conditioner compressor; removing
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
and installing A/C compressor .
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Fit poly V-belt ⇒ page 38
– Electrical connections and cables ⇒ Rep. gr. 97 ; Relay car‐
rier, fuse holder and electrical boxes; Installation location over‐
view - Relay carrier, fuse holder and electrical boxes and
⇒ Current flow diagrams, Electrical fault finding and Fitting lo‐
cations.
– Install engine control unit - J623-
– Connect coolant hoses with plug-in connector
– Install pendulum support
– Assembly mounting: adjusting
– Install battery tray ⇒ Electrical system; Rep. gr. 27 ; Battery;
Removing and installing battery tray .
– Install air cleaner housing.
– check oil level⇒ Maintenance ; Booklet 501 .
.
⇒ page 197 .
.
⇒ page 187 .
⇒ page 264 .
.
⇒ page 239
⇒ page 31 .
⇒ page 32 .
⇒ page 226
León 2013 ➤ , León ST 2013 ➤
.
⇒ page 179 .
1. Removing and positioning the engine
23