León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove securing bolt -arrows- for gearbox.
– Pull off connector for oil level and oil temperature sender -
G266-
⇒ page 137
.
– Unscrew all sump securing bolts -arrows-.
– Unscrew sump securing bolts on gearbox side -arrows- using
Allen key, long reach - T10058- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Note
The sump is sealed with liquid sealant ⇒ Electronic parts
♦
catalogue .
When hardened, the sealant has a high adhesive strength.
♦
– Carefully lever off sump from cylinder block at recess -arrow-
using assembly lever.
– Remove oil pan. Loosen sump with light blows of a rubber
headed hammer if necessary.
– Eliminate the sealant residue from cylinder block, using a flat
rasp.
132
Rep. gr.17 - Lubrication