Seat Leon 2013 Workshop Manual page 142

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Rotate oil pump gear to a position where 2 opposing notches
-arrows- are aligned vertically.
– Fit oil pump onto dowel pins.
Specified torques
– Tighten new securing bolts -1- to 8 Nm + 90°.
– Tighten the bolts -2- to 20 Nm.
– Install new crankshaft oil seal on belt pulley end
– Install oil pan ⇒ page 130
– Install alternator ⇒ Electrical system; Rep. gr. 27 ; Alternator;
Removing and installing alternator .
– Secure tensioner with new fastening screws -arrows-.
– Install toothed belt ⇒ page 95
Specified torques
♦ ⇒ "1.1 Exploded view - sump/oil pump", page 126
♦ ⇒ "1.1 Exploded view - poly V-belt drive", page 35
136
Rep. gr.17 - Lubrication
⇒ page 46
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.