Seat Leon 2013 Workshop Manual page 148

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Screw 2 studs a few turns into holes -arrows-.
Note
Observe use-by date of sealant.
– Cut off nozzle of tube at front marking (nozzle ∅ approx. 1.5
mm).
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Note
Danger of blocking lubrication system with excess sealant.
♦
Do not apply sealant bead thicker than specified.
♦
– Apply bead of sealant -arrow- onto clean sealing surface of oil
separator as shown in illustration.
• Width of the sealant line: 2 mm
The oil separator must be installed within 5 minutes after applying
the sealant.
– Place oil separator over studs and support on engine block.
– Unscrew studs again.
– Tighten bolts to specified torque observing specified tightening
sequence ⇒ page 140
Remaining installation sequence carried out in reverse sequence;
note the following:
– Install front noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
Specified torques
♦ ⇒ Fig. ""Oil separator - tightening torque and sequence"" ,
page 140
♦ ⇒ "2.2 Exploded view - electric coolant pump", page 159
142
Rep. gr.17 - Lubrication
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
respect to the correctness of information in this document. Copyright by SEAT S.A.
.