Seat Leon 2013 Workshop Manual page 79

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Removing
Note
Attach all heat-shielding sleeves in the same places when instal‐
ling.
– Remove camshaft housing
– Remove intake manifold
– Unplug electrical connectors:
1 - At oil pressure switch for reduced oil pressure - F378-
2 - at fuel pressure sender - G247-
3 - On injectors -N30- to -N33- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Unscrew bolt -2- and remove screw-type clip.
– Remove bolt -1- and nuts -arrows- and tie up catalytic con‐
verter.
– Remove bolts -arrows- and detach heat shield for drive shaft
(right-side).
– Remove heat-shield sleeve
⇒ page 76 .
⇒ page 229
León 2013 ➤ , León ST 2013 ➤
1. Cylinder head
73